Front plates often don't carry registration stickers, so many drivers find them superfluous.Front plates tend to protrude a bit from the front of the car and get crushed and mangled in parking.The Honda HR-V offers a clean, well-lighted place for a rear license plate. As a result the front plate usually looks tacked on. Carmakers seldom create a nice well for a front plate the way they do for rear plates.
Alternatively, you could decide to stick the new plates in place instead. If the hole is enlarged, then a larger drill bit would be required when re-riveting – if you plan to do so. Normally, the procedure would be to use the same sized drill bit as was used for fixing, but this will enlarge the existing hole, so use a slightly smaller drill bit if that’s possible. Pop rivets are not used that often to fix car number plates, and removing them can pose more of a challenge than screws or adhesives. They might then have been locked into place using a rivet gun. Pop rivets are tubular-shaped metal fixings, and they are fitted into a pre-drilled hole.
How to remove pop rivets from a number plate If still more assistance is required, the application of heat can be helpful, so try using a hairdryer or heat gun to loosen the adhesive. Just wrap some around your fingers, and work it back and forth behind where the number plates are stuck, working your way along until the number plate can be removed. This method cuts through the stickiness while avoiding damage to your vehicle’s bodywork. If the plates are more firmly attached, the best technique is to use some dental floss, fishing line or string to aid removal. Place your fingers under the edge of the number plate and pull firmly but evenly. Some stuck-on number plates can easily and quickly be removed. You can use this method to remove either sticky pads or tape. How to remove double sided tape from a car number plate It is worth retaining your current number plates if you want to screw on your new number plates, as you can use these as a template to show exactly where the screw holes should go. If this is the case, see below for a guide on how to remove these. You also need to be aware that some screwed-on number plates will have had double sided tape or sticky pads applied, to improve adhesion. Make sure you hold the plate firmly after the screws have been taken off, as this stops the plate falling and causing damage to your car. It’s wise to take care when doing this, however. Once the screws are loose, you can pull the number plate off. Once any screw covers are out of the way, you can proceed with unscrewing. These are usually white, black or perhaps yellow plastic caps that hide the screws and give a neater finish. If your number plates are fixed by means of screws, the first thing to do is to remove any plastic screw covers, if there are any. Here is a brief guide to removing your number plates, depending on how they were fixed onto your vehicle: How to remove screws from a number plate The process of removal differs slightly for each option. They will have been secured with screws or pop rivets, or they will have been stuck on with super strong double sided tape or sticky pads. The first step in removing the old number plates is to determine exactly how they have been fixed on. Before you try to remove your number plate They will arrive in the post any day now, so you need to start thinking about how to physically take off the old number plates in preparation. You’ve found the perfect private number plate, and New Reg has sorted out the transfer paperwork with the DVLA and we’re producing your new plates. So you’ve made the decision to change your standard number plate for a personalised one.